My Homepage

11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

You will be surprised to see just how to spray on car paint really can not be difficult. That does not mean that you go at it and can only grab a tin of paint. There are some principles you should understand. Both in application and the preparation.

Step A:

Prepare by gathering all your items that you are going to need.

Step B:

You may need to examine the car for any rough spots. These will need to be sanded with 300 grit sand paper. Additionally, it allows the aerosol car paint to stick better. Make certain all of the dust soil and debris are taken off the vehicle after you have finished sanding. It's imperative that the automobile be perfectly clean.



Step C:

You'll need to apply a primer. This will make sure that you get an overall even coat of your coloured paint plus helps the paint to adhere nicely. When you spray the primer, make sure you apply light coats and allow for drying in between. How exactly to spray on auto paint takes a little getting used to.

Step D:

Now you might be well to the point at which you might be about ready to spray on the colour. You may have decided to use the spray auto paint that comes in aerosol cans, or maybe you've selected for the spray Alloy Wheel Repair Harold Hill gun. In either case, make a few practice strokes on an item before you begin with the car. Start the passes with the paint without reluctance, once you might be ready. You may end up getting uneven coverage, if you hold the spray can or gun in one area and perhaps the paint will run. If it happens you have a significant repair job on your had. You will most likely have directions regarding how you can spray on auto paint using the gear or spray cans.

Step E:

You might want to research this choice on the internet, or check with someone which is familiar with just how to spray car paint

Step F:

Once you happen to be fully satisfied with the shade, you're down to the finishing touches. You will now want to apply several coats that are clear. This will give the shine and finished appearance to the car in addition to protect the finish. Likely two coats will be adequate but it's going to be up to you personally. Make absolutely sure it is dry in between coats.

Step G:

If you favor once more, you've got the option of wet sanding. Again, I will suggest you request the advice of people which can be comfortable with how to paint an automobile. You need with these grits in this sequence if you determine to follow this step then. Use 800, 1000, 1200, 1500 and the ultimately the 2000. This will remove spots which will be too heavy in the clear coat application.

Step H:

Step I:

You should now buff the surface. To try this simply use a moderate cut polish.

Step J:

As a final touch, you might want to apply several coats of wax.

This website was created for free with Own-Free-Website.com. Would you also like to have your own website?
Sign up for free